Fort Myers Drain & Sewer Logo
    Get EstimateCall Now
    Sewage Lift Station Repair in Fort Myers, FL

    Sewage Lift Station Repair in Fort Myers, FL

    When gravity alone can't move wastewater, a lift station does the work. We connect you with a licensed local pro who can repair or maintain yours.

    Signs Your Lift Station Needs Attention

    Alarms going off at the control panel

    Slow drainage or backups in a home or property on flat or low-lying ground

    Unusual noise, odor, or visible overflow near the station

    The pump running constantly, or not running at all

    A pump that runs constantly is often just as concerning as one that doesn't run at all. Continuous running usually means a float switch isn't shutting it off properly, which can burn out the pump motor well before the station would otherwise need service.

    How Lift Station Repair Works

    1

    Diagnose the Problem

    A licensed pro checks the pump, the wet well, floats, and electrical components to find out what's actually failing.

    2

    Confirm the Fix Needed

    Sometimes it's a pump issue, sometimes it's a float switch or electrical control problem. You get a clear answer before any work starts.

    3

    Repair or Replace the Failed Part

    Pumps and components get repaired or replaced as needed, using parts built for the make and model of your system.

    4

    Test Before Leaving

    The station gets tested under normal operation to confirm it's moving wastewater the way it should.

    What a Sewage Lift Station Actually Does

    A sewage lift station exists because wastewater doesn't always have enough of a downhill slope to reach the main sewer line or treatment facility on its own. The station collects wastewater in a holding chamber called a wet well, then uses a pump to lift it up and over to where gravity can take over again.

    The pumps themselves are typically off-the-shelf brands built specifically for this job, names like Zoeller, Myers, Hydromatic, and Homa show up regularly in lift station equipment lists. Knowing the brand and model matters when a repair is needed, since replacement parts aren't universal across manufacturers.

    A lift station failure isn't always dramatic at first. A float switch stuck in the wrong position, a clogged impeller, or an electrical control issue can all cause a station to stop working properly well before an alarm actually trips, which is part of why early signs like a slow drain on flat ground are worth paying attention to.

    Lift stations are typically enclosed or below ground for a real reason: the wet well can generate methane and hydrogen sulfide gas, both hazardous in an enclosed space. This is a big part of why this isn't a job to open up and troubleshoot yourself, and why the pros we connect you with treat it as confined-space, licensed-professional work.

    Why Lift Stations Matter Here

    Fort Myers is flat and low-lying in a lot of areas, which means gravity alone can't always move wastewater where it needs to go. Lift stations handle that job, both for homes and for commercial properties.

    When a lift station fails, it doesn't always announce itself right away. An alarm, a slow drain, or a bad smell near the station are usually the first signs, and catching it early avoids a bigger backup later.

    Storm season adds extra strain. Heavy rain and power outages are two of the most common reasons a lift station stops working when you need it most, since these systems depend on electricity to run the pump. If yours goes down during a storm, our 24/7 Emergency Service is available.

    What Lift Station Repair Typically Costs

    Common repairs vary widely depending on what's actually failing. Electrical or float switch issues typically run $500 to $2,000. Impeller cleaning or replacement generally runs $500 to $1,500. A full pump replacement runs $3,000 to $10,000. Wet well corrosion repair or recoating, a real ongoing maintenance need given the constantly corrosive environment inside, typically runs $1,000 to $5,000.

    If a full new lift station is needed, residential installations generally run $3,000 to $10,000, while commercial installations run $10,000 to $50,000 or more depending on flow rate and pump requirements. Emergency, unplanned pump replacement typically costs 50 to 100% more than the same repair done on a planned, scheduled basis.

    These are typical ranges, not a quote. Your actual cost depends on what's failing, your system's brand and model, and whether the repair is planned or urgent.

    Example Job — HOA Community, San Carlos Park

    The Problem

    An HOA-managed community in San Carlos Park lost power during a summer storm. When power came back on, several homes on the lower end of the development started experiencing slow drains, and the community's shared lift station wasn't cycling the way it should.

    The Diagnosis

    A technician found the float switch had been knocked out of position during the outage and power restoration, which meant the pump wasn't triggering correctly even though it was undamaged and otherwise functional.

    The Fix

    The connected contractor repaired and reset the float switch, then tested the station through several normal operating cycles to confirm it was triggering and shutting off correctly before leaving.

    Recurrence Prevention

    Given how often storms and power outages affect systems like this one, the HOA was advised to add the lift station to a post-storm-season check as routine practice, rather than waiting for the next outage to reveal a problem.

    Sewage lift station float switch repair after a storm-related power outage in San Carlos Park

    Float switch repair restoring normal lift station operation for an HOA community after a summer storm

    ItemCost
    Diagnosis and float switch repair$500–$2,000
    Total$500–$2,000

    Costs vary by what's actually failing and the system's brand and model — this reflects a typical float switch/electrical repair and is not a quote. A free estimate from your connected professional will confirm exact pricing for your property.

    Why Property Owners Work With Us on This

    We Diagnose the Real Issue

    Pump, float switch, or electrical problem, you get a straight answer on what's actually wrong.

    Licensed and Verifiable

    Every pro in our network is licensed for this work in Florida. You can check any contractor at myfloridalicense.com before work starts.

    Residential and Commercial

    We connect you with pros who handle lift stations for homes, HOAs, and commercial properties alike.

    We Know Fort Myers Terrain

    Flat, low-lying ground is common here, and so are the problems that come with it. We know what to look for.

    Common Questions

    Related Services

    Areas We Serve

    Fort Myers, Cape Coral, North Fort Myers, Iona, San Carlos Park, Buckingham

    Lift Station Acting Up? Let's Get It Checked.