Hydro-Jetting in Fort Myers, FL
A full pipe wall clean, not just a path through the clog. We connect you with a licensed local pro who has the equipment to do it right.
What Hydro-Jetting Actually Is
Hydro-jetting uses a specialized nozzle that sprays high-pressure water in multiple directions as it travels through the line, typically in the 1,500 to 4,000 PSI range depending on pipe size and condition. That multi-directional spray scours the entire interior surface of the pipe, not just a path through whatever's blocking it.
A mechanical snake, by comparison, punches a channel through a clog and restores flow fast, but it doesn't touch the grease film, scale, or buildup lining the rest of the pipe. That's why a drain that "was just cleaned" with a snake often clogs again within a few months, while the same buildup, once actually removed with jetting, typically doesn't return for two to three years.
A camera inspection before jetting is often a good idea, not a formality. It confirms the pipe can structurally handle jetting pressure, since jetting an already-compromised or badly deteriorated line can make existing damage worse instead of better.
When Hydro-Jetting Is the Right Call
A drain keeps clogging even after being snaked
Grease buildup is a suspected or confirmed cause
Root intrusion is present and needs more than a simple cut
You want a full clean, not just symptom relief
For a one-time, isolated clog, snaking is often the faster, cheaper option. For a recurring problem, jetting is usually the fix that actually holds, and the math tends to favor it once you account for how often a snake-only fix has to be repeated.
How Hydro-Jetting Works
Assess the Line
A camera inspection, where appropriate, confirms jetting is the right call and the pipe can handle it.
Set Up the Equipment
A hose is fed into the line connected to a high-pressure water source and the appropriate nozzle for the job.
Jet the Full Length
The nozzle travels the line, its multi-directional spray scouring the interior wall along the way, not just clearing a path through a blockage.
Confirm the Result
Flow is confirmed clear, and a camera pass can verify the interior is actually clean, not just flowing.
Why This Comes Up Here
Older Fort Myers neighborhoods with original cast iron pipe are especially prone to internal scaling and root intrusion, both of which jetting addresses more thoroughly than mechanical snaking alone.
Restaurants and commercial kitchens throughout Fort Myers deal with steady grease loads that build up along pipe walls over time, which is exactly the kind of buildup jetting is built to remove.
What Hydro-Jetting Typically Costs
General residential hydro-jetting typically runs $250 to $1,500, with a commonly cited average around $475. Main sewer line jetting specifically typically runs $600 to $1,500. A separate service call or diagnostic fee, often $50 to $200 or more, may apply on top depending on the provider.
These are typical ranges, not a quote. Your actual cost depends on line length, severity of buildup, and whether a pre-jetting camera inspection is needed.
Why Fort Myers Homeowners Call Us
Right Tool for the Job
We connect you with pros who choose jetting when it's actually the better fix, not just the more expensive option.
Licensed and Verifiable
Every pro in our network is licensed for this work in Florida. You can check any contractor at myfloridalicense.com before work starts.
Camera-Confirmed Results
We connect you with pros who can confirm the line is actually clean, not just flowing again.
Residential and Commercial
From a single-family home to a restaurant kitchen line, we connect you with pros who handle both.
Areas We Serve
Fort Myers, Cape Coral, North Fort Myers, Iona, San Carlos Park, Buckingham